Amprobe Multitest-1000 Continuity-Tester Manuel d'utilisateur télécharger pdf (Page 48)

7. INSTRUMENT CONNECTION TO A PC

The connection between PC and instrument is created using the serial port and optical

serial cable, provided with the software package.

Before making the connection it is necessary to select the COM port used for the

transmission. To set this parameter start the software and look up the help on line.

ATTENTION

: The selected port shall NOT be shared by other devices or applications

(example mouse, modem, etc.)..

To transfer the stored data from the instrument to the PC keep to the following procedure:

1. Turn the switch on position RS232.

FUNC

2. By means of the FUNC key select the mode "SEr":

Then proceed according to the software instruction manual to transfer the

measurements performed.

)

The communication between

instrument and PC occurs.

Note

: The download speed is: 9600 baud (see software instruction manual).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 121 122

Pas de commentaire

Amprobe Multitest-1000 Continuity-Tester Manuel d'utilisateur Page 48