Amprobe Multitest-1000 Continuity-Tester Manuel d'utilisateur télécharger pdf (Page 29)

4.3.2. Anomalous cases which may occur during phase sequence tests

)

VOL

In the case that every delta voltage is

lower than 100V, the instrument does

not perform the test and displays the

screen alongside.

Message “Lo VOL tAG”: the instrument has at

least one low voltage. The instrument does not

perform the test.

)

ν A

If the voltage present at the T1 input is

too low, when START/STOP is pressed

the instrument displays the message

alongside.

Message “Att no

L1”: voltage of

phase 1 is too low

)

ν A

If the voltage present at the T2 input is

too low, when START/STOP is pressed

the instrument displays the message

alongside.

Message “Att no

L2”: voltage of

phase 2 is too low

)

ν A

If the voltage present at the T3 input is

too low, when START/STOP is pressed

the instrument displays the message

alongside.

Message “Att no

L3”: voltage of

hase 3 is too low

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 121 122

Pas de commentaire

Amprobe Multitest-1000 Continuity-Tester Manuel d'utilisateur Page 29