Amprobe DMIII-Multitest Power-Quality-Recorder Manuel d'utilisateur télécharger pdf (Page 19)

AMPROBE

DMIII MULTITEST

EN-17

6.1.3. Results of "AUTO" mode



At the end of the test, if

the average resistance

value Ravg is lower

than 5 the instrument

emits a double sound

signal indicating the

positive outcome of

the test and displays a

screen similar to the

screen to the right.

LOW 05.06.01

Average resistance value

(Ravg)

1.05

R+ R-

1.07 1.03

219mA 219mA

AUTO 0.11

Resistance values and

corresponding test currents

obtained after exchanging

the polarities of test leads

FUNC

CAL

The displayed result can be stored by pressing the SAVE key twice (refer to

paragraph 9.1).

6.1.4. Results of "RT+" and "RT-" modes



If a resistance value

RT+ or RT- lower than

5 is detected, the

instrument emits a

double sound signal

indicating the positive

outcome of the test

displays a screen similar

to the screen to the

right.

LOW 05.06.01

Max Resistance value of

R+ or R-.

1.07

219mA

RT+ 0.11 TIME: 10s

Test current

Duration of the Test

FUNC

CAL





Note: We recommend the use of alligator clips and to assure the alligator clips make good

contact with the conductor under test. Indeed, in this test the instrument gives as a

final result the maximum measured value of R+ or R- and using test leads instead of

alligator clips could give you faulty results due to faulty contact between the test leads

and conductor under test

The displayed result can be stored by pressing the SAVE key twice (refer to

paragraph 9.1).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Amprobe DMIII-Multitest Power-Quality-Recorder Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Amprobe DMIII-Multitest Power-Quality-Recorder